So, I don't even have a legitimate reason to say why I made these. I just had an excess of crepe paper so I figured it would be cool to make flowers with them. I think at this point I'm going to get an opaque, coloured jar or vase and fill it with Styrofoam and stick these in. I made a TON. But I only took pictures of this one.
WHAT YOU'LL NEED:
Crepe paper
Scissors
Hot glue gun
Q-tips
Wire cutters or pliers
Ribbon (optional)
INSTRUCTIONS:
STEP 1: Choosing the colour you want for your crepe paper flower petals, cut a sheet out so that it's dimenions are a height of roughly 2-2.5 inches and a length of 3 ft. Cut the petal shapes out on one side of the crepe paper sheet, leaving the other edge flat. Make sure it the sheet is still connected.
STEP 2: For the stamen and stem, use a q-tip (cotton ear bud), or even a wooden skewer or dowel. If you are using a cotton ear bud, use the wire cutter or pliers to cut off the cotton bud off.
STEP 3: Apply hot glue to the ear bud. From this point forward, I will be referring the ear bud as the "stamen" because essentially that is what the ear bud is being reproduced as.
STEP 4: Starting from the edge of the crepe paper petals, start TIGHTLY rolling the sheet onto the stamen where the glue is applied. Be careful not to rip the paper. Continue this until the sheet is finished.
So when you're done, shape up the petals all nice and fluffy-like, it should then look something like this
*The following steps are optional*
STEP 5: Apply hot glue to the bottom edge of the crepe paper and roll green ribbon over it until the base of the flower is entirely covered. Cut the ribbon, glue secure.
ET VOILA!
DIY Crepe Paper Flowers!
If you take the time to cut out individual petals, you can also make other types of flowers. but now that you know the basics, you can use your own imagination and creative thinking to customize the design of the flower and the looks and shape of the petals can be entirely unique to your own :)
Cheers!
czaR2-D2
No comments:
Post a Comment